Gear Production Suite – Release 4.3
We are pleased to announce the release of version 4.3 of our gear software.
BGA Congress 26th November 2009
The BGA Congress was held at Augusta-Westland, Yeovil. The event was very well attended in general given the condition of the market at this point and this was due in part to the opportunity to have a tour of the facilities. Dontyne was not exhibiting or presenting this year, but will consider submitting a paper for next year.
It was good to see so many familiar faces, and we wish them all well in 2010.
AGMA Fall Technical Meeting 13-15th September 2009
After joining the American Gear Manufacturers Association (AGMA) earlier in the summer, representatives from Dontyne attended the AGMA Fall Technical Meeting in Indianapolis in September.
Advanced Gear Design Course – 29th September 2009
We have once again received considerable interest in running our Advanced Gear Design Course.
Dontyne Systems Sponsors Prudhoe Cricket Club
Dontyne Systems is proud to support this local cricket club.
NorthStar Equity Investment
The development of the Machine Centre module will take a leap forward as funding has been obtained from the North East Proof of Concept Fund managed by NorthStar Equity Investors Limited.
Joint Paper accepted for AGMA FTM
The Technical Paper written by Rob Frazer of The Design Unit in Newcastle “Optimising Gear Geometry for Minimum Transmission Error, Mesh Friction Losses and Scuffing Risk”, has been reviewed and accepted by a review panel for presentation at the 2009 Fall Technical Meeting 13-15 September in Indianapolis, USA.
Partnership with GBE (Canada) for sales and services in North America – May 2009
Dontyne is pleased to announce the formation of a partnership with GBE of Canada www.gbengineering.ca.
Advanced Gear Design Course
Following our extremely successful Knowledge Transfer course in September 2008, we have received considerable interest in arranging another and are therefore pleased to attach information on our next course, to be held on 2nd April 2009. Read the rest of this story »
